Thermo nanopure manual

Remove the old 0. Remove the new 0. Gently turn it clockwise until it is fully seat- ed. Remove the protective cap from the filter bell. Rinse liters … Setting the Displayed Language 1. During normal Recirculation mode, a purity and temperature reading will be printed once every 12 minutes.

For additional setup and operation, refer to the instruction manual included with the printer. The system electronics will initialize and check its calibration.

All units have been factory calibrated. Connect the 9 pin serial cable part no. Resetting the Cleaning Timer 1. Setting the Cell Constant The actual temperature and cell constants are attached to the cell cable internal to the Nanopure unit.

This data helps ensure that the purity displayed is as accurate as possible. Shut power OFF to the unit and disconnect the power cord. Unlatch and open the right side door. Find and copy down the two cell constants attached to the gray cable, leaving the electron- ics board mounted on th … This is espe- cially convenient to ensure the unit is placed in Standby during weekends. System electronics failure.

Replace the resistivity meter board mounted on the inside of the right door. Water is leaking between the Wing head screws are not Tighten wing head screws on unit manifold and the cartridge tight enough. New cartridge pack: o-ring missing Disconnect inlet water and from pos … After cleaning is complete approximately 3. If you have installed an Accudispense volumet- ric remote dispenser, place it in manual mode.

Clean your Nanopure TOC - UV and replace the cartridge pack when the product water purity drops below acceptable levels of resistivity, when organic levels become too high, or if a new 0.

The simple-to-use c … You should see the data on the computer screen. When you are finished storing data from the Nanopure, save your file. You can exit Hyperterminal or set up a new experiment. Procomm 1.

Description Part No. Place a container under the dispenser. Water will start dispensing immediately! Some spare parts and all of the replacement filters are still available. Uf membrane. These systems were available as a 3 and 4 housing version.

You will find the replacement filters and other parts for the system in this section. Operating Manual How to change the filters in this device. Brand: Barnstead. Category: Water System. Type: Operation manual. Pages: Choose from a three- or four-module system. Gain longer cartridge life and benefit from lower operating costs with large cartridges. Replacement filters and parts are still available.

Type I. Ultrapure water system supplies Type I water with resistivity up to Filters for Barnstead Water Systems great www. Useful Blogs. About us Bartenderry.